(Broadcast can prevent the application from finding the server in the IP address defined) If the nethasp.ini file is defined correctly and the client can recognize the server (using the Monitor) and the software does not run you can try disabling the broadcast parameter in the Nethasp file:.You can troubleshoot this using 'Aladdin Monitor' available at this address: Make sure that the server has a static IP address and that the clients and server can communicate properly.Make sure the full file name is 'Nethasp.ini'.You need to define in each client the IP of the server.Make sure port # 475 is enabled in the firewall.If the hasp license manager is not installed on the server, plese follow these instructions: If the hasp license manager is installed as a service you should see it running in windows services: (Start->Run->msconfig->Services)

If the hasp license manager is installed as application you should see running in windows taskbar: The hasp license manager can be installed in two ways:

Make sure that the hasp license manger is installed and running correctly on the server.(computer where dongle is connected).

If no light is turned on, try moving the dongle to a diffrent USB port.

Make sure the dongle is connected to the server, and check to see that the USB light is turned on.

Install the 'Sentinel license manager'.

When having problems with installation of SolidCAM network dongle, please follow these steps: NOTE! These instructions are for a network USB dongle Click here for instructions when using a network product key WITHOUT a USB dongle SolidCAM network dongle - troubleshooting

Solidcam inventor